Command line interface DBF to DBF Converter
Common parameters
| /OVERWRITE=1 | Overwrite existing file. |
| /OVERWRITE=0 | Do not overwrite existing file. (Append to existing file). |
| /ASIS | Codepage as is. |
| /ANSI | Convert to ANSI codepage. |
| /OEM | Convert to OEM codepage. |
| /OPEN=1 | Open the output file after conversion. |
| /OPEN=0 | Do not open the output file after conversion. |
| /BATCH | Batch mode. Do not ask any questions (if possible). |
| /SILENT | Batch mode. The program does not display any windows. |
| /WAIT | Do not close the program at the end. (Wait on the finish page). |
| /LOG | Create a log file in a common repository for application-specific data. A typical path is C:\Documents and Settings\username\Application Data. |
| /STATUS /STATUS=filename.ext | Create a text file with a current status (Conversion In Progress, Successful, Failed, Cancelled etc). By default: %Program dir%\status.log |
| /FILTER=condition | It allows you to convert records which satisfy the condition. |
DBF specific parameters
| Drive:\Path\FileName.dbf | Source DBF file |
| Drive:\Path\FileName.dbf | Target DBF file If you run the program in a batch mode using wild cards then you should specify a folder, i.e. Drive:\Path\ |
| /DBASE3 | Convert to dBase III format. |
| /DBASE4 | Convert to dBase IV format. |
| /FOXPRO | Convert to FoxPro format. |
| /VFP | Convert to Visual FoxPro format. |
| /LEVEL7 | Convert to dBase Level 7 format. |
| /BLOCKSIZE=????? | Set blocksize for memo fields. Example: /BLOCKSIZE=128 |
| /RECALL=1 | Remove a deleteion mark from the output file. |
| /RECALL=0 | Keep a deletion mark in the output file. (default) |
